Hi - did a search without a clear answer so here goes.... I'm using a std Ford Mondeo coil pack, crank and cam sensors (the later for sequential fueling and eventually COP's) but I need to know how the 3 pins are positioned - I guess the centre is 12v but which side is 1/4 & 2/3. I have the std mondeo plug so even wire colours would be useful. Then the other two, looking at the sensor plug how are signal & ground arranged ?
I know I can wire then swop around but would like to avoid the faffing around whilst curing all the other inevitable problems!
Polarity / pin out Questions
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Polarity / pin out Questions
Cant help, but there is no guarantee the centre is 12v either.
Maybe try measuring resistance across them ?
I'd think if you measured between the two firing pairs...you shouldnt get a reading ?
But between 12v and a firing coil, you would get a reading through the windings ?
Maybe try measuring resistance across them ?
I'd think if you measured between the two firing pairs...you shouldnt get a reading ?
But between 12v and a firing coil, you would get a reading through the windings ?
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Polarity / pin out Questions
I've just checked a mondao coil I have and the center one is 12v, the left is the left pair or coils when viewed from the connector and right right pair.
Re: Polarity / pin out Questions
Thanks Rob - that pretty much the way I was leaning!