Hello,
Why in S60 it isn't possible to activate the throttle blip on downshift ?
In fact I would just increase the ignition on dowshift ?
Best regards
Shift Cut S60 : Throttle blip
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Shift Cut S60 : Throttle blip
How do you want to trigger the blip?
-
- Posts: 12
- Joined: Tue May 12, 2020 10:10 am
- ECU Model: S60 Pro
- Distributor: LORRTEC
- Firmware Version: 89.00
Re: Shift Cut S60 : Throttle blip
I have seen in other topic (S100 shift cut parameters) you writed : "Shift Cut End Point isn't used for shifting, but is now used for throttle blip on downshift".
And I had supposed that it's possible with gear position potentiometer ?
I have an other question on shift cut parameter when we use "USE SWITCH TO START, POT TO FINISH" if you want to activate gear dependant time table how is used the colum Delay Time ?
Thank you
Best regards
And I had supposed that it's possible with gear position potentiometer ?
I have an other question on shift cut parameter when we use "USE SWITCH TO START, POT TO FINISH" if you want to activate gear dependant time table how is used the colum Delay Time ?
Thank you
Best regards
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Shift Cut S60 : Throttle blip
It was something to do with how the outputs were coded on the S60, but I don't remember the details.
If you use switch to start and pot to finish, the delay is not used. It's only used when Delay Only is selected.
If you use switch to start and pot to finish, the delay is not used. It's only used when Delay Only is selected.