DTAForum.com - a forum for the DTA ECU

Hi! on my S100 when testing at a race track testing the Flappy paddle setup i noticed no speed displayed on my dash!
for some reason the ecu is not seeing the omron proximity sensor on the diag setup?the sensor lights up when the target tooth is in place the question is
can i make the ecu use my un driven wheel be the one that runs my speedo? via can the dash (aem cd7) does everything via can and speed is in there!
for the rear setup i use 5v cam hall effect sensors

From memory, you need to have Traction Control enabled in the pull-down window (even if the manual switch is OFF) to get the undriven wheel speed to be recorded/enabled.