Page 2 of 2
Re: turbo target pressure map
Posted: Thu May 28, 2020 3:45 pm
by TRN
This is what I mean, which I don't understand. Shouldn't the turbo target pressure table be TPS vs RPM, regardless of the user selecting TPS or MAP as load?
Re: turbo target pressure map
Posted: Thu May 28, 2020 5:39 pm
by stevieturbo
Ahh yes...that doesnt make a lot of sense.
Re: turbo target pressure map
Posted: Fri May 29, 2020 2:34 am
by Alex DTA
@stevieturbo, TRN isn't talking about the base PWM table, he's talking about the turbo target table, where the values are a boost target.
@TRN I think you have a box ticked that you shouldn't. Turbo target should have RPM as it's Y axis, and TPS as it's X-axis. In Turbo Parameters, make sure the option "Use MAP for PWM X Axis" is not ticked.
Re: turbo target pressure map
Posted: Fri May 29, 2020 4:09 am
by katana
Damn you are good - I was just about to point the OP there!
Re: turbo target pressure map
Posted: Fri May 29, 2020 4:12 am
by TRN
Yes that solved it! Thanks again!!
Re: turbo target pressure map
Posted: Fri May 29, 2020 9:12 am
by stevieturbo
Alex DTA wrote:@stevieturbo, TRN isn't talking about the base PWM table, he's talking about the turbo target table, where the values are a boost target.
@TRN I think you have a box ticked that you shouldn't. Turbo target should have RPM as it's Y axis, and TPS as it's X-axis. In Turbo Parameters, make sure the option "Use MAP for PWM X Axis" is not ticked.
Software glitch then that allows this to happen ?