Page 1 of 1
Lamda control settings
Posted: Fri Jan 10, 2020 11:34 pm
by c2turbo
this should be an easy one I am running dual lamda sensors but I am unable to select the cylinder per sensor, what do or don't I have selected correctly ( this is a flat 6 911 engine)I have
attached a jpg of the setting I am currently using
Re: Lamda control settings
Posted: Sat Jan 11, 2020 4:28 am
by Rob Stevens
In red on the screen it's indicating that this feature can't be used in batch fire mode.
You will have to add a cam sensor and initiate sequential injection for this to work.
Re: Lamda control settings
Posted: Sat Jan 11, 2020 5:32 am
by stevieturbo
Yep...annoyingly you must be running full sequential in order to have two lambda sensors connected.
Which means in batch fire, you cannot even use this input for logging.
Re: Lamda control settings
Posted: Sat Jan 11, 2020 9:05 am
by Alex DTA
stevieturbo wrote:Yep...annoyingly you must be running full sequential in order to have two lambda sensors connected.
Which means in batch fire, you cannot even use this input for logging.
This was changed over a year ago.
Update the firmware, and you can run batch fire and two lambda sensors.
Re: Lamda control settings
Posted: Sun Jan 12, 2020 4:32 am
by Rob Stevens
Doh, make mental note to update my PC software!
Re: Lamda control settings
Posted: Sun Jan 12, 2020 6:43 am
by stevieturbo
Rob Stevens wrote:Doh, make mental note to update my PC software!
Or the ecu firmware lol