Hi does anybody know what the wiring sould be on the tps plug?
should it be this:
1-5v
2-signal
3-Earth
Pepper
c20let tps wiring
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: c20let tps wiring
You need to identify the resistive track, best done with an ohm meeter. Take the meter and set to resistance, take the 2 meter leads and connect them to all the connectors in turn whilst moving the pot, if the resistance stays the same you have identified the resistive track. The other one must be the wiper. now, you need to identify the track the right way round, connect the meter to the wiper and each other in turn to identify the end of the track that the wiper goes to at full throttle (the resistance drops) this one should have the 5v, the other one earth and the wiper is the signal.
I think its important that you follow these instructions as it will help you understand what's required, rather than just randomly changing things.
I think its important that you follow these instructions as it will help you understand what's required, rather than just randomly changing things.