Xdash communication error

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
Capos
Posts: 11
Joined: Wed Sep 07, 2022 3:39 pm
ECU Model: S80 Pro
Firmware Version: 80

Xdash communication error

Post by Capos »

Ok, so I'm using a Xdash SN151 with my DTA S80. Have experienced some problems with it, and found another used Xdash which I picked up thinking it would be an easy swap.

However, I have a communication error with the new one when I try to upload my screens to it.
It was working with the seller's computer, but it's not working with mine.

Using Windows 7, X-dash 3.18 software
Old X-dash serial number 151
New X-dash serial numer 253
Error code is "Communication Error" when I try to sync between computer and dash (Same for downloading data from the dash)
Just replacing the dash - using the same loom in the car etc so I really cant understand why I don't get it to work.

Where should I start looking?
Is there someway I can reset the "new" dash?
Post Reply