Hi,
how do I set input2 to respond to oil pressure ?
s40 pro v57-oil press
-
- Posts: 18
- Joined: Sun Jan 23, 2022 6:37 pm
- ECU Model: S60 Pro
- Firmware Version: 78.01
- Location: Paso Robles, California
Re: s40 pro v57-oil press
In DTASwin, use Other Map Settings->Analogue2 and Aux2 to select the Primary Input as Analogue 2 Volts and Secondary Input as OIl Pressure, Make sure the voltage range in the first column covers your sensor range. Then use Engine Configuration->Sensor Scaling->Oil Pressure to convert the sensor output voltage to kPa.
Re: s40 pro v57-oil press
the error was in an incorrect sensor voltage range setting / the sensor had a different resistance than VDO