Hi quick question. Wish to use map 2 with a small ignition offset. I've setup the switch and can copy across ignition and fuel maps but what other settings do I need to make ?
Thanks
Map2 settings
Re: Map2 settings
You just need to go into other map settings > ALS parameters/map2 > ALS parameters/map2 and select map2/ALS control on and activate when switch on.
Re: Map2 settings
Thanks
Seems easy and was helped by being able to copy across fuel and ignition map. Tested in garage and appears to switch and still run at idle
Seems easy and was helped by being able to copy across fuel and ignition map. Tested in garage and appears to switch and still run at idle
-
- Posts: 602
- Joined: Fri Dec 04, 2009 1:45 am
- ECU Model: S80 Pro
- Distributor: DTA UK
- Firmware Version: 73
- Location: Pennsylvania, USA
- Contact:
Re: Map2 settings
I wish you could switch or invert the logic between switching map1/map2. Reason being, I use an Aquamist HFS6 water injection system and when the system is functioning normal it closes the output, meaning my "normal" map is Map2.
1992 700RWHP Pump Gas BMW
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Map2 settings
Just use a relay?
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Map2 settings
or a transistor ?
Or better still....assuming you have spare analogue inputs.
Fit a pressure sensor onto the WI line, and apply any fuel/spark corrections based on line pressure ( flow sensor would be better, but these seem hard to come by in suitable format )
The above is cheap, simple and by nature builds in a failsafe system and doesnt need MAP2 at all, which could maybe be used in a different manner if needed.
Or better still....assuming you have spare analogue inputs.
Fit a pressure sensor onto the WI line, and apply any fuel/spark corrections based on line pressure ( flow sensor would be better, but these seem hard to come by in suitable format )
The above is cheap, simple and by nature builds in a failsafe system and doesnt need MAP2 at all, which could maybe be used in a different manner if needed.