I just finished installing a GM content sensor and now when i open the diag screen the shift cut switch cycles between on and off do i need to change something in the input settings
Thanks Dave
E85 sensor and shift cut switch light
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: E85 sensor and shift cut switch light
The diagnostic screen just shows the hardware is working. This will cycle, as the E85 sensor outputs a PWM signal.
You can ignore that.
You can ignore that.