How can I use or can I use a Map senor that is not listed in the Preset list when i change the values in the table it does not save the settings even if i update and save the map ?
what am i doing wrong ?
Thanks Dave
Using non listed preset map sensor
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Using non listed preset map sensor
If you have the scaling, simply enter the values in the table and save.
Re: Using non listed preset map sensor
The main issue I am having is it will not let me enter a period for .5 volts or 4.5 volts
the period does not work on the volt table for me but works fine on the psi table i am confused if it is only entered in mv then why are there periods in the presets?
Thanks David
the period does not work on the volt table for me but works fine on the psi table i am confused if it is only entered in mv then why are there periods in the presets?
Thanks David
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Using non listed preset map sensor
There aren't periods in the voltage table, those are all millivolts.
The thousands separator is entered automatically as a format mask. If you type 4000, it will show as 4,000 in the UK, and 4.000 in Europe.
The thousands separator is entered automatically as a format mask. If you type 4000, it will show as 4,000 in the UK, and 4.000 in Europe.