Good morning.
@katana, thanks for the information, I'm in the process of implementing it this way.
I have now noticed that with flywheel mode 0 without a coil per plug, only spark plugs 1 and 3 spark. Cable checked and connections checked, everything OK. That's not correct, all spark plugs should spark. I then activated the coil via plug and all sparks up to 2000 rpm. If I go to 0 rpm, nothing works anymore and if I set it to 50 rpm, it works again. Because the starter doesn't make that many revolutions. Sequential is not enabled. Something is wrong, do I have to wire the ECU connector differently?
Thanks and best regards
Andreas
And please excuse my english, I hope it is understandable.
Honda B16A ignition coil burned out
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Honda B16A ignition coil burned out
Turn off coil per plug.
In General Engine Settings, turn on Twin Spark.
In General Engine Settings, turn on Twin Spark.