Turbo Parameters question

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
Liam
Posts: 4
Joined: Wed Oct 07, 2020 2:55 am
ECU Model: S40 Pro
Distributor: MEF Motorsport
Firmware Version: 79.06

Turbo Parameters question

Post by Liam »

Hi,

Quick question about the S series Turbo Parameters screen: do I need to tick "Turbo Control On?" for my Turbo Over Pressure protection to be enabled or is putting a value in the Turbo Over Pressure field enough?

Cheers
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Turbo Parameters question

Post by Alex DTA »

Turbo Control must be on
Liam
Posts: 4
Joined: Wed Oct 07, 2020 2:55 am
ECU Model: S40 Pro
Distributor: MEF Motorsport
Firmware Version: 79.06

Re: Turbo Parameters question

Post by Liam »

Alex DTA wrote: Tue Jan 11, 2022 3:38 pm Turbo Control must be on
Thanks Alex. Unfortunately I can’t switch turbo control on as I’m using AUX2 for the fan.

Bit of a shame the boost cut functionality is bound by this as I doubt it needs the presence of a solenoid to work.
Rob Stevens
Posts: 1247
Joined: Thu Jul 28, 2011 4:10 am
ECU Model: S100 Pro
Distributor: None-Coil On Plug :)

Re: Turbo Parameters question

Post by Rob Stevens »

Cheap alternative would be a stand alone temp switch for the fan?
Or move the fan to aux 6 and run the taco direct from a coil?
Post Reply