Page 1 of 2

E48

Posted: Fri Nov 19, 2021 9:07 am
by DCVR1
Hi
Can anybody help please i have a E48 on a fiat twin cam 2ltr with 40s jenvey throttle bodies on essential engine settings what should i put in for these
1/injector dead time
2/the offset
3/switch injector
I have done all others and set timing
Hope someone can help
Cheers Dave

Re: E48

Posted: Sat Nov 20, 2021 4:25 am
by Rob Stevens
1/injector dead time 0.7 will do unless you have data on your injectors
2/the offset 0.0 only applicable if you have twin spark plugs
3/switch injector NA , only applicable if you are using 2 injectors per cylinder, make sure you have 1 injector selected
Rob

Re: E48

Posted: Sat Nov 20, 2021 6:08 am
by DCVR1
Thank you Rob will try it today
Dave

Re: E48

Posted: Sat Nov 20, 2021 6:51 am
by DCVR1
Hi
Is there a base map (Fuel/Ignition)i can load into ECU just to run engine before goes to rolling road
I have a map in ecu at present but no idea if right.I have the map on laptop so can take photos of maps and send by whats app if anybody got the time
My Mobile 07473953979

Re: E48

Posted: Sat Nov 20, 2021 9:36 am
by Rob Stevens
Hi
The 1800 VW map that is in the software should be a good start, just make sure you get the crank trigger type correct and the position BTDC right as you can

Re: E48

Posted: Sat Nov 20, 2021 10:25 am
by DCVR1
Hi Rob
Thank you so much for your help where can i down load the vw map
Cheers Dave

Re: E48

Posted: Sun Nov 21, 2021 3:25 am
by Rob Stevens
it is already in the DTAwin software that you must be using to connect to the ecu. Try it off line File>Open>1800VW>Open

Re: E48

Posted: Sun Nov 21, 2021 10:01 am
by DCVR1
Thank you Rob
Engine running will get booked in at rolling road
Cheers again Dave ;) ;)

Re: E48

Posted: Sun Nov 21, 2021 2:50 pm
by Rob Stevens
;)
Nice one

Re: E48

Posted: Wed Feb 23, 2022 3:45 pm
by n16boo
hi all,

just about to buy a 1.4 k series which is running the e48 ecu, once fitted in to my new car i thought be worth checking on the rollers encase different exhausts ect make it run leaner/richer but I'm struggling to find someone in the south that has the patients to set up the e48...
can anyone suggest a garage that doesn't mind setting the car up with this ecu?