S100 road speed

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
Andy-reid
Posts: 58
Joined: Sun May 27, 2018 3:28 pm
ECU Model: S80 Pro
Distributor: DTA Direct
Firmware Version: 73.01
Location: Berkshire

S100 road speed

Post by Andy-reid »

Hi! on my S100 when testing at a race track testing the Flappy paddle setup i noticed no speed displayed on my dash!
for some reason the ecu is not seeing the omron proximity sensor on the diag setup?the sensor lights up when the target tooth is in place the question is
can i make the ecu use my un driven wheel be the one that runs my speedo? via can the dash (aem cd7) does everything via can and speed is in there!
for the rear setup i use 5v cam hall effect sensors
SMR
Posts: 137
Joined: Tue Jan 16, 2018 9:38 am
ECU Model: S100 Pro
Distributor: DTA
Location: Aberdeen

Re: S100 road speed

Post by SMR »

From memory, you need to have Traction Control enabled in the pull-down window (even if the manual switch is OFF) to get the undriven wheel speed to be recorded/enabled.
Post Reply