Hello
How to connect memtool to Xdash. USB,RS232 or CAN?
Thanks for the help
Margus
Xdash firmware
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Xdash firmware
For any programming, use the USB connection.
To update the firmware, you will need Infineon Memtool.
If you just want to change the layout, use XConf.
To update the firmware, you will need Infineon Memtool.
If you just want to change the layout, use XConf.
-
- Posts: 4
- Joined: Thu Apr 09, 2020 12:04 pm
- ECU Model: No ECU
Re: Xdash firmware
I have the Memtool but it is not connecting to Xdash thru USB. Port is right, dash is in programming mode.
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Xdash firmware
You're holding both buttons down when powering on the XDASH?