the car does not turn on, I do not have injectors and coil, I put an oscilloscope, but it does not start
first:
after reviewing. but it does not start
tomorrow I will change the cables for others with better shielding,
and I'll try
Problema with S60 cosworth
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Problema with S60 cosworth
You have a cam sensor issue. That should run fine with sequential/cams turned off.
-
- Posts: 3586
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Problema with S60 cosworth
Exactly what is it using for a cam sensor ?
Normal cosworth "Phase" sensor was inside the distributor, and had 2 teeth. This would not be usable without a little modification.
Normal cosworth "Phase" sensor was inside the distributor, and had 2 teeth. This would not be usable without a little modification.
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Problema with S60 cosworth
Post up the map. It may be that the sequential or other settings have been changed somehow.
When you say the ecu is ok on another engine, is it exactly the same engine and sensors or did you change the map?
When you say the ecu is ok on another engine, is it exactly the same engine and sensors or did you change the map?
Re: Problema with S60 cosworth
I test on another engine by changing the map
Re: Problema with S60 cosworth
the car does not start with the cartography that it had previously, and it takes 1 year with her, it had another cartography made with a bigger bridle and it did not start either.
I put a standard and if you turn on, very weird. I modified something in my cartography and now it starts but it shuts down and it has a lot of gas ....... Sensors are ok.
very strange, and if I have handled the programming I had before does nothing ...
I put a standard and if you turn on, very weird. I modified something in my cartography and now it starts but it shuts down and it has a lot of gas ....... Sensors are ok.
very strange, and if I have handled the programming I had before does nothing ...
Re: Problema with S60 cosworth
failure map sensor,