DTAForum.com - a forum for the DTA ECU

Ok Alex, I will send an email

Thanks Alex,
can you provide the data for us to complete the screen to run closed loop in our bmw s65 engine when we add the 2nd wide band sensor. We plan to order the Innovate DLG-1 system unless you have a better suggestion to work with the S100

Hi Alex, we also want to run two wideband sensors and have the data sent to our race technology pod dash. Can the updated firmware capture both sensors data and send to the dash using the Can stream?

we want to run our bmws65 race car engine in closed loop, currently running in open loop with one wideband sensor.

Hi Alex, This is what was displayed, the current firmware is as follows:
DTA Swin V82.16 - ECU:- S100V62.01 COMS: - RS232
What do you think, should we update?
Ralph

Thanks Alex, I will check

what are the benefits in upgrading to the latest s100 firmware? How to I go about uploading the new firmware to the s100 unit?
Ralph

Ok thanks

Thanks Alex,
So that's all, just connect the signal to pin#3 and install these settings and I am good. Do you suggest dyno time to fine tune the settings. Any other suggestion before I get started.
Regards,
Ralph

Alex,
That's great news, can you provide the detailed settings in the DTA s100 software?
Also, do I connect the shifter to the #14 pin in the s100 wiring?
Regards,
Ralph