DTAForum.com - a forum for the DTA ECU

In the launch control settings, select limit rpm when button pressed and set an rpm.

Is there any chance of more boost control maps? I've been dabbling with a Garrett servo type wastegate actuator in an attempt to get a wider range of control of boost by gear but it really needs more maps to function effectively.

According to the documentation I found it's not compatible with the dta as neither of the two outputs cover the entire range of the sensor. One covers zero to 20 some degrees and the other 20 to 90!

would it be possible that when you are in the software on the data log> logging options screen you had the ability to toggle between say three sets of user defined logging parameters. In my case I like to have have the log permanently recording a basic bunch of channels at ten hertz, but say you wan...

It looks to me like the air temperature compensation is your problem. At 18degC it's showing +1% fuel at 22degC it's showing -100%

You just need to go into other map settings > ALS parameters/map2 > ALS parameters/map2 and select map2/ALS control on and activate when switch on.

Did you have the engine running? I'm pretty sure that the map won't switch unless it is.

Iirc if you open the shift settings page in dtaswin and click on help it tells you which pin to use.

This may just be me misunderstanding, but on the shift cut parameters page, number of gears is configurable from 1-7, the gear voltage table goes to 7, but the gear dependent settings table goes to 8.

I haven't used one but have been looking into getting one and having a play with the software. It can do wiper, hazards etc but it all needs to be configured through the software.