DTAForum.com - a forum for the DTA ECU

does anyone know the configuration of these coils as opposed to the 3 wire versions?

Right , I have mine all hooked up mechanically and wiring wise ,I have a 12 way pot to vary ana 1 between 5v and 0v and a Gt101 on the front wheels, ive filled out the fields for all the wheel speeds etc . I just need some initial traction settings for slip percentage ,cut etc etc any ideas? The car...

Its all about ohms law........... If you use a 4.7k resistor between the 5v feed and Ana 1 and then a switching resistor network between ana 1 and 0v you create a variable voltage to ana1 IE , if you want 3.5 volts at ana 1 this means 1.5v dropped across the 4k7 resistor, using ohms law I=V/R (1.5/4...

I quite like the idea of that 12 click potentiometer, so does anyone its resistance value ?
If its 5k linear would you use a 4.7k pullup to 5v? Ie almost a 50/50 split?
Could the same 50/50 split be applied if the 12 position pot was 10k ,ie a 10k pullup ?

Any recommendations of which type wheel speed sensor also dash level adjust pot type /value to use on Ana 1 ?

Has anyone got a start up map for one of these please?

Now sold , thanks for the enquiries

comes from a still born project . P8 pro ecu only used on dyno, never installed in a car G dash , brand new in original case with all new leads etc Raychem touring car wiring loom for KV6 engine also available with connections to P8 pro Cost the best part of £2000 new for the ecu and dash .............

Ive got one thats only been powered for an hour or two ,bought it with a G dash which is still in its case and has never been used .
Would like to sell them together , make me your best offer........