DTAForum.com - a forum for the DTA ECU

Alex DTA wrote: ↑Tue Jan 11, 2022 3:38 pm Turbo Control must be on

Thanks Alex. Unfortunately I can’t switch turbo control on as I’m using AUX2 for the fan.

Bit of a shame the boost cut functionality is bound by this as I doubt it needs the presence of a solenoid to work.

Hi,

Quick question about the S series Turbo Parameters screen: do I need to tick "Turbo Control On?" for my Turbo Over Pressure protection to be enabled or is putting a value in the Turbo Over Pressure field enough?

Cheers

katana wrote:White - 0-5v Analog Input.

Easy as that, thanks very much.

I'm assuming "4 wire Bosch" is the correct voltage scale in the software? Or is it just a case of trial and error until the ECU and gauge are reading in sync?

Thanks again

Hi all, I have an S40 Pro and an AEM X-Series UEGO AFR sensor controller gauge (30-0300). I wish to wire the AEM into the ECU for reference. There is a 2 pin connector on my DTA engine loom for the wideband and I'm told that pin 1 is signal and pin 2 is sensor ground. Looking at the AEM wiring diagr...